Download
PE WPC Boards: Surface Water Stains — Causes and Fixes
Why water stains appear on PE WPC board surfaces, how lubricant bleed causes them, and four ways to reduce them.
Customers sometimes complain that PE WPC boards develop water stains, in different shapes and sizes, for no clear reason. Wall panels and fence boards are reported most often. Decking is different: it is walked on and rubbed every day, so deposits have little chance to build up. A wall panel or fence board touches nothing, so marks show up on their own. Customers ask why it happens and how to stop it happening again — and many producers have no good answer.
Why water stains appear
1. First, rule out other kinds of marks
A mark on the surface is not always a water stain. Before blaming water, check these other possible causes:
- Pollution in the place where the board is used — for example, kitchen cooking fumes settling on the surface over a long time.
- Acid rain corroding the surface.
- Mildew growing on part of the surface.
- Carbon black used to match a colour. Poor-quality carbon black fades, and if it is not mixed evenly or not plasticised well, the colour changes unevenly.
- Unknown substances in the air sticking to the surface.
- A weak plastic in the formula, or the wrong amount of additive, or poor plasticising and mixing, causing local ageing and weathering.
- Low-molecular-weight polymers bleeding out and forming oil stains, which then trap dust.
2. How a water stain forms
Once the causes above are ruled out and the mark is confirmed as a water stain, the mechanism is simple. A drop of water sits on the surface for a long time and picks up dust from the air. When the water evaporates, the minerals in the water and the dust it collected stay behind, exactly where the drop was — and that is the stain. Given time, more minerals and dust build up in the same place, and the stain gets more and more visible.
Oily substances on the surface make it worse. Where the surface is oily, surface tension stops the water spreading evenly: on a flat surface it beads up, and on a vertical surface it forms drips and irregular patches under gravity, much like a lotus leaf after rain or a car windscreen. The drop picks up dust, the water evaporates, and the dust and minerals are left where the drop was. Those deposits lower the surface tension in that spot, so the next time water comes it gathers there even more easily — a vicious circle. A fresh stain is white; as white particles build up, it turns black.
3. Where the oily substances come from
So the way to reduce water stains is to reduce the oily substances on the board surface. On PE WPC boards, the small oily molecules on the surface mainly come from three places:
- Low polymers and waxy substances produced when the plastic breaks down during processing, which migrate to the surface as the board is extruded — much like grease working its way out of a cloth when it is wrung.
- Small molecules in the lubricants, such as PE wax, oxidised polyethylene wax or other fatty small molecules.
- Other additive carriers that come in masterbatch form.
4. How to reduce them
- Ask the lubricant supplier whether the composite lubricant contains a large amount of small molecules that bleed out easily.
- Improve the formula. Some wall and fence boards can use a certain amount of LDPE, which improves the flow of the material and makes the mix easier to process, so less lubricant is needed — keep the total lubricant below 1.2%.
- For different profile shapes and board thicknesses, ask the lubricant supplier to adjust the balance between internal and external lubricants, so the total amount of lubricant comes down.
- If the lubricant goes above 1.8%, or the lubricant contains a large amount of PE wax, a large amount of small molecules will bleed out. There are two reasons: the lubricant itself bleeds out, and too much lubricant speeds up the bleeding of the low polymers produced when the plastic breaks down. Some of those low polymers are oily and sticky, and they cause serious stains and water stains.
