Download

PE WPC Boards: Why Boards Warp and How to Fix It

Why PE WPC boards warp — uneven cooling, warm cooling water and asymmetric profiles — and how to fix each cause.

Boards that come out warped are one of the most common problems on the factory floor. This note sets out why it happens and what can be done about it, in plain terms.

Why boards warp

Warping gets worse in summer. As the weather warms up, the cooling water warms up too, so a board coming out of the sizing die into the cooling tank does not cool as well as it should. A board that is not cooled properly is easy to warp — and in summer, producers hear about it more often.

1. The two faces cool at different speeds

If a board's two faces are not identical, uneven cooling is the first thing to check — but it can happen even on a fully symmetric board. Take a hollow board whose holes are regular and whose top, bottom, left and right are all symmetric: if it still warps, the likely cause is that the two faces cooled at different speeds and shrank by different amounts.
Fix: check that the board is fully under the water while it cools, so the top and bottom faces cool at exactly the same speed.

2. The cooling water is too warm

When the water is too warm, cooling cannot keep up. A board that has not finished cooling and is then laid unevenly on the unloading rack will deform and warp.
Fixes:
  • Fit a fibreglass cooling tower and run it in summer to bring the cooling water temperature down.
  • A smaller plant can top up the cooling circuit with deep-well water to help bring the temperature down — ideally to below 30 °C.
  • Level the unloading rack, and lay each board flat on the cart as soon as it comes off the rack.
  • When stacking boards, alternate them face up and face down.

3. Asymmetric profiles warp most easily

A profile is asymmetric when: (a) its left and right, or its top and bottom, are not symmetric; (b) the top and bottom are the same width, but one face is smooth and the other is grooved; or (c) both faces are grooved, but the grooves differ in number, width or depth. These boards warp far more easily than symmetric ones.
The reason is in the mould. Because the mould is not symmetric top to bottom, the material flows at different speeds and under different pressures on the two faces — one side fast, the other slow. That builds up internal stress, and the board warps as it cools.
The warp pattern tells you what happened. A common case: a board with one grooved face and one smooth face warps with the grooved face bulging upward and the smooth face bending down. The grooved side meets more resistance in the mould and the smooth side less, and the mould was never designed to balance the flow, so the pressure difference between the two faces warps the board.
Fixes:
  • While cooling, deliberately keep one face fully under the water and the other only partly under.
  • Adjust the mould temperatures on the top and bottom faces according to the warp direction, and use the temperature difference to change the material's flow speed and pressure and correct the warp.
  • Turn the mould 180 degrees so the top and bottom faces swap over, then apply the first or the second fix — or both together.
  • If none of the above works, send the mould back to its maker to rework the flow channel in the transition plate.

Read next

More from T*Home

Installation guides and material notes for WPC decking, wall cladding and fencing.